Nemo group Company ®



QUICK INSTALLATION

Cut the pipe in the groove with tube cutter ; Slide on the back nut, fit the segment ring to the last groove, tighten the fitting to provide a flat end; Unscrew connection, insert washer and tighten again

FITTINGS

In the past, it was impossible to rule out crevices inside the hose at the attachment point of fittings. At these positions, adhering residual fluids present in stronger concentrations could cause crevice and/or pinhole corrosion. With burr and crevicefree connection systems, this is out of the question.

INFORMATION

There are many different types of hose on the market such as stainless steel, rubber, PTFE, fabric and composite so it can be difficult when to decide to use metal. Below are several crucial facts for choosing steel

NemoFlex® and all Nemo-based marks are trademarks or registered trademarks of Nemo group Company ® in the Turkey and/or other countries
© 2008 All rights reserved.